The electrical equipment of the machine that sets the bracket depends on the left side of the electrical cabinet. It is composed of a set of micro-switches such as a handle, a guide shaft, a spring, and a bumper. Great deviation. You can use the manual handle to check whether there is any stuttering. Clean it in time to see if there is any foreign body. Set the lower end of the bracket for the micro-switch. Check whether the micro-switch is damaged or not. It will be different when cutting. To perform a better switch inspection, you can directly measure with a multimeter. Out. When the timer of the cutting machine is on the electrical cabinet, if the shade is different, it must be replaced directly. If there are black spots inside the electric cabinet of the cutting machine, they should be removed and replaced in time. use: The cutting machine is to place the machine on the flat cement, check whether the various parts of the machine are complete and firm, and the line is smooth. Remove some debris on the platen and work surface. Fill oil into the tank with anti-wear hydraulic oil. Xiaobian recommends using 68 # or 46 # anti-wear hydraulic oil. The oil level should not be less than 25 mm above the filter screen. Before connecting to the 380V power supply, press the oil pump button, adjust and keep the motor rotation consistent with the direction of the arrow. We first control the cutting machine depth, the left rotation of the control button is zero. When we turn on the power, we need to press the start button of the oil pump. The no-load operation takes two minutes, and we need to observe whether the system can run normally. The push-pull plate, rubber plate, workpiece, and die should be stacked in the center of the work table in order. To set and analyze the cutting die of the cutting machine, loosen the knife setting handle and the bottom will be locked naturally.